Tips to Save Heating Costs in the Winter

The freezing, winter months can be difficult for most families. Aside from the biting cold, they also have to fend off rising energy bills due to heating appliances.

Sacrificing your family’s comfort by not activating your electric heater can help save your bill. However, it is not a recommended step. And besides, there are a lot of other steps that you can take to ensure that your energy bill stays low during winter. If you take a tour inside and outside your home, you will realize that a little bit of DIY renovations here and there can help you save up.

Check out this short article to learn useful hacks for saving heating costs during winter!

  1. Immediately replace any worn out weather stripping.

Before the cold season even starts, make sure that the weather stripping on your doors or windows are replaced. Broken weather strippings are not effective because they let the cold drafts enter your house. If the cold air seeps in, you will be forced to make the furnace work harder. Thankfully, you only need to replace your weather stripping every few years or so. Plus, it’s as easy as pulling it off from the door, and then sticking on the new one.

  1. Door thresholds should be adjusted.

If you close your front door and light is still seeping inside your room, it means that you are still losing a lot of the indoor heat that you have paid for. The door should be in contact with the threshold so that the warm air will stay inside and not out. There are several types of thresholds with adjustable heights. If you have one, all you need to do is to rotate the screws in a counterclockwise position. When adjusting the gap between your door and the threshold, make sure that the threshold is not extremely high so that you can still open and close the door without damaging the weather stripping.

  1. Remove the drafts around the electrical boxes.

Cold drafts can enter around the electrical boxes because they are not really well-insulated. Even though these boxes only take up some small space, it’s still recommended that you reinforce their insulation because they can still contribute to your energy expenses if left unattended.

In order to prevent warm air from escaping through the electrical boxes, fill in the small gaps using latex caulk. If the gaps are too huge, cover them with foam sealant. Afterwards, replace the cover plate with a foam gasket.

  1. Seal holes in the outer walls.

Usually, electrical cables or gas lines have openings that are covered with caulk. As time goes by, the caulk breaks down or peels off, creating gaps where the cold air from the outdoors can enter. If the holes are bigger, it can also be a gateway for rats, insects, or small pests to enter your home.

Simply use expanding foam to seal these gaps.

  1. Cover the windows with plastic film.

Windows with gaps are one of the main reasons why a house can lose its indoor heat. You can effectively trap most of the heat by sealing the window with a plastic film. The good news is that you can buy a roll of transparent film for a cheap price. It is also very easy to trim and install.

  1. Use an inflatable chimney balloon to seal the chimney.

One of the biggest disadvantages of using a traditional fireplace is that cold air can escape through the chimney when you are not using it. If the flue is sealed, some of the warm air can still escape through it.

Dismantling your fireplace can be an expensive solution to your problem. So the best option is to buy an inflatable chimney balloon. Simply blow the balloon and just attach it to your chimney — it’s as simple as that. If you forgot to remove it before starting a fire, it will automatically deflate. This way, you won’t have to sacrifice your rustic fireplace just to save on energy bills. However, please be reminded that the balloons can be filled with soot if you do not remove them after some time.

  1. Buy a modern thermostat.

At first glance, upgrading your thermostat may seem costly, but in fact, it’s actually a good way to reduce your energy costs at home. That’s because modern thermostats have programmable settings that allow users to automatically turn it off once it achieves the right temperature.

Thanks to the technological advances, these devices are extremely cheap. You can now buy an advanced thermostat for just $25 or less.

  1. Fill up your dishwasher before using them.

Using the dishwasher numerous times a day can eat up so much energy. So before using this cleaning appliance, make sure that you fill it up first. Not only is this method energy-efficient, but it can also help save water in your home.

Leave a Reply